Installation – Thinklogical HDX80 Manual User Manual
Page 29
Revision A
December 2011
21
Installation
All physical connections to the product use industry-standard connectors. Non-supplied cables
that may be needed are commercially available. All connections are found on the rear of the
unit.
Figure 23: Typical HDX576 Router Application using SDI Xtreme 3G+ Extenders
Set-Up
Note: Insure that all thumb screws are finger tight so that all the modules
are properly held in the chassis.
1. Carefully remove the HDX Router from its shipping container. Inspect the HDX
Router to make certain that no damage occurred during shipment.
2. All of the I/O cards are installed at the factory to meet the configuration. Insure
that the I/O cards are properly seated in the unit. All of the I/O cards have
thumb screw retainers.
3. After checking the I/O cards, go to the top of the unit. There are two power
supplies located in the top part of the chassis. Verify that the power supplies
are secure in the chassis.