Connecting the coax cable, Figure 2-7. installing the ac power cord, Figure 2-8. connecting the coax cable – Visara 1330-X02 User Manual
Page 23: Connecting the coax cable -9, Figure 2-7, Installing the ac power cord -9, Figure 2-8
701333-004
2-9
Preparing to Operate the 1330
transformers, power distribution panels, and motors). The unit should not be installed
where the atmosphere contains corrosive elements that may damage the unit.
Cable runs should avoid areas that produce electromagnetic interference (for example,
near transformers, switching equipment, power distribution panels, and under carpets
where vacuum cleaning is done). Also, heavy equipment should not be moved or rolled
over the cable.
Power-On/Off
Switch
AC Power Cord
Receptacle
Figure 2-7. Installing the AC Power Cord
After installing the ribbon cartridge and connecting the 1330 to a power source, you are
ready to connect the coax cable.
Connecting the Coax Cable
Before you connect the coax data cable, make sure the Power switch is in the
O
(OFF)
position.
Route the coax cable to the coax connector receptacle on the back of the 1330. See
Figure 2-8. Plug the cable connector into the receptacle and turn the connector clockwise
until the slots on the side of the connector lock against the studs on the side of the
receptacle.
Figure 2-8. Connecting the Coax Cable