Allmand Brothers MB 6200 - Manual (Page 55)

55
Problems
The following table provides a troubleshooting guide. It contains problem identification, probable cause and
suggested corrective action to take in order to solve the problem.
Note
& &
Your application may or may not contain some of the System Elements
listed in the troubleshooting table.
System Element Problem Probable Cause Corrective Action
Power
When the MAIN
POWER switch is
switched to ON position,
there is no indication of
power to the BRICK
system. MAIN POWER
switch is turned
off. Turn on MAIN POWER
switch.
System fuse. Check System fuse.
Replace if necessary.
Batteries do not stay
charged. Poor electrical
connections. Check all battery
connections for loose
wires, corrosion, or
frayed wires. Replace
or repair as necessary.
Check all ground and
power studs for loose or
missing cable
connections. Tighten if
necessary.
Dry battery. Check electrolyte level
of all batteries. See
figure 1 for additional
information. Add
distilled water as
required. Then recharge
battery.