H3C Technologies H3C S10500 Series Switches - Manual (Page 56)

48
2. Configuration procedure
# Enter system view.
<Sysname> system-view
# Configure WRR queuing on GigabitEthernet 1/0/1.
[Sysname] interface GigabitEthernet 1/0/1
[Sysname-GigabitEthernet1/0/1] qos wrr
[Sysname-GigabitEthernet1/0/1] qos wrr 0 group 1 weight 1
[Sysname-GigabitEthernet1/0/1] qos wrr 1 group 1 weight 2
[Sysname-GigabitEthernet1/0/1] qos wrr 2 group 1 weight 4
[Sysname-GigabitEthernet1/0/1] qos wrr 3 group 1 weight 6
[Sysname-GigabitEthernet1/0/1] qos wrr 4 group 1 weight 8
[Sysname-GigabitEthernet1/0/1] qos wrr 5 group 1 weight 10
[Sysname-GigabitEthernet1/0/1] qos wrr 6 group 1 weight 12
[Sysname-GigabitEthernet1/0/1] qos wrr 7 group 1 weight 14
Configuring WFQ queuing
Configuration procedure
Follow these steps to configure WFQ queue:
To do… Use the command… Remarks
Enter system view system-view —
Enter
interface
view interface interface-type interface-number
Enter
interface
view or port
group view
Enter port
group view
port-group manual port-group-name
Use either command.
Settings in interface view take
effect on the current interface.
Settings in port group view take
effect on all ports in the port group.
Enable byte-count or
packet-based WFQ queuing qos wfq [ byte-count | weight ]
Required
The default queuing algorithm on
an interface is SP queuing.
For a
byte-count
WFQ queue
qos wfq queue-id group group-id
byte-count schedule-value
Configure
the
scheduling
weight for a
queue
For a
packet-based
WFQ queue
qos wfq queue-id group group-id weight
schedule-value
Select a command according to
the WFQ type (byte-count or
packet-based) you have enabled.
If you have enabled WFQ on the
port, byte-count WRR applies by
default, and the default scheduling
weight is 1 for each queue.
Configure the minimum
guaranteed bandwidth for a
WFQ queue
qos bandwidth queue queue-id min
bandwidth-value Optional
64 kbps by default for each queue.
Display WFQ queuing
configuration
display qos wfq interface [ interface-type
interface-number ] [ | { begin | exclude |
include } regular-expression ]
Optional
Available in any view