HEIDENHAIN MANUALplus 4110 Pilot User Manual
Page 12
12
W
o
rkpiece blank
Blank Bar/Tube
The cycle describes the workpiece blank and the setup used. This
information is evaluated during the simulation.
Information on cycle parameters:
X:
Outside diameter
Z:
Length (including transverse allowance and clamping range)
I:
Inside diameter for workpiece blank ”tube”
K:
Right edge (transverse allowance)
B:
Clamping range
J:
Type of clamping
• 0: No clamping
• 1: Outside clamping
• 2: Inside clamping
Workpiece blank contour ICP
The cycle integrates the workpiece blank defined with ICP and describes
the setup used. This information is evaluated during the simulation.
Information on cycle parameters:
X:
Clamping diameter
Z:
Clamping position in Z
B:
Clamping range
J:
Type of clamping
• 0: No clamping
• 1: Outside clamping
• 2: Inside clamping
N:
ICP contour number