HEIDENHAIN MANUALplus 4110 Pilot - Manual (Page 92)

92
End-f
ace mac
hining
End-face linear path cycle G101
Geometry: G101 defines a path on an end-face contour.
Parameters
X:
Target point (X as diameter value)
C: Target angle – angle direction: see support graphics
XK, YK: Target point (Cartesian coordinates)
A: Angle to the positive XK axis
Q: Point of intersection – default: Q=0
• Q=0: Near point of intersection
• Q=1: Remote point of intersection
B: Chamfer/rounding
• B left undefined: Tangential transition
• B=0: Non-tangential transition
• B>0: Rounding radius
• B<0: Chamfer width
Machining: The tool moves at the feed rate along a linear path to the
target point.
Parameters
X:
Target point (X as diameter value)
C: Target angle – angle direction: see support graphics
XK, YK: Target point (Cartesian coordinates)
Z: Target point (infeed)