HEIDENHAIN MANUALplus 4110 Pilot User Manual
Page 51
51
Definition of
W
o
rkpiece Blank
Chuck part, cylinder/tube G20
G20 describes the workpiece blank and the setup used. This
information is evaluated during the simulation.
Parameters
X:
Diameter
Z:
Length (including transverse allowance and clamping range)
K:
Right edge (transverse allowance)
I:
nside diameter for workpiece blank ”cylinder.”
B:
Clamping range
J:
Type of clamping
• 0: No clamping
• 1: Outside clamping
• 2: Inside clamping
Workpiece blank contour G21
G21 describes the setup used. The workpiece blank is described with
G1, G2/3 and G12/13 commands that follow immediately after G21. G80
concludes the contour description.
This information is evaluated during the simulation.
Parameters
X:
Clamping diameter
Z:
Clamping position in Z
B:
Clamping range
J:
Type of clamping
• 0: No clamping
• 1: Outside clamping
• 2: Inside clamping