HEIDENHAIN iTNC 530 (60642x-04) ISO programming - Manual (Page 158)

158 Programming: Programming Aids
4.5
3-D
line
gr
aphics
(FCL2
function)
Highlighting NC blocks in the graphics
 Shift the soft-key row
 To highlight the NC block selected in the left window
in the 3-D line graphics in the right window, set the
MARK THIS ELEMENT OFF / ON soft key to ON.
 To not highlight the NC block selected in the left
window in the 3-D line graphics in the right window,
set the MARK THIS ELEMENT OFF / ON soft key to
OFF.
Block number display ON/OFF
 Shift the soft-key row
 Show block numbers: Set the SHOW OMIT BLOCK
NR. soft key to SHOW
 Hide block numbers: Set the SHOW OMIT BLOCK
NR. soft key to OMIT
Erasing the graphic
 Shift the soft-key row
 Erase graphic: Press CLEAR GRAPHICS soft key