HEIDENHAIN iTNC 530 (60642x-04) ISO programming - Manual (Page 508)

508 Manual Operation and Setup
14.6
Using
to
uc
h-pr
obes
14.6 Using touch-probes
Overview
The following touch probe cycles are available in the Manual Operation
mode:
Please note that HEIDENHAIN grants a warranty for the
function of the touch probe cycles only if HEIDENHAIN
touch probes are used!
Function Soft key Page
Calibrating the effective length Page 513
Calibrating the effective radius Page 514
Measuring a basic rotation using a line Page 518
Setting the datum in any axis Page 522
Setting a corner as preset Page 523
Set a circle center as preset Page 524
Setting the centerline as preset Page 525
Measuring a basic rotation using two
holes/cylindrical studs Page 526
Setting a preset using four
holes/cylindrical studs Page 526
Setting a circle center using three
holes/cylindrical studs Page 526