HEIDENHAIN iTNC 530 (60642x-04) ISO programming - Manual (Page 572)

572 Test Run and Program Run
16.6
Optional
bloc
k
skip
16.6 Optional block skip
Application
In a test run or program run, the control can skip over blocks that begin
with a slash "/":
 To run or test the program without the blocks
preceded by a slash, set the soft key to ON
 To run or test the program with the blocks preceded
by a slash, set the soft key to OFF
Erasing the "/" character
 In the Programming and Editing mode you select the block in which
the character is to be erased
 Erasing the "/" character
This function does not work for TOOL DEF blocks.
After a power interruption the TNC returns to the most
recently selected setting.