HEIDENHAIN iTNC 530 (60642x-04) ISO programming - Manual (Page 66)

66 First Steps with the iTNC 530
1.
5
Set
ting
up
tools
The pocket table TOOL_P.TCH
In the pocket table TOOL_P.TCH (permanently saved under TNC:\) you
specify which tools your tool magazine contains.
To enter data in the pocket table TOOL_P.TCH, proceed as follows:
 Display the tool table
 Display the pocket table
 Edit the pocket table: Set the EDITING soft key to ON
 With the upward or downward arrow keys you can
select the pocket number that you want to edit
 With the rightward or leftward arrow keys you can
select the data that you want to edit
 To leave the pocket table, press the END key
Further information on this topic
 Operating modes of the TNC: See "Operating modes", page 76
 Working with the pocket table: See "Pocket table for tool changer",
page 187
The function of the pocket table depends on the machine.
Your machine manual provides more detailed information.