HEIDENHAIN iTNC 530 (60642x-04) ISO programming - Manual (Page 64)

64 First Steps with the iTNC 530
1.
4
Gr
aphically
te
sting
the
first
par
t
Starting the test run
 Press the RESET + START soft key: The TNC
simulates the active program up to a programmed
break or to the program end
 While the simulation is running, you can use the soft
keys to change views
 Press the STOP soft key: The TNC interrupts the test
run
 Press the START soft key: the TNC resumes the test
run after an interruption.
Further information on this topic
 Running a test run: See "Test Run", page 555
 Graphic functions: See "Graphics", page 544
 Adjusting the test speed: See "Setting the speed of the test run",
page 545