HEIDENHAIN iTNC 530 (60642x-04) ISO programming - Manual (Page 67)

HEIDENHAIN iTNC 530 67
1.
6
W
o
rk
piece
set
u
p 1.6 Workpiece setup
Selecting the correct operating mode
Workpieces are set up in the Manual Operation or Electronic
Handwheel
mode
 Press the Manual Operation operating mode key: the
TNC switches to that mode
Further information on this topic
 Manual Operation mode: See "Moving the machine axes", page 480
Clamping the workpiece
Mount the workpiece with a fixture on the machine table. If you have
a touch probe on your machine, then you do not need to clamp the
workpiece parallel to the axes.
If you do not have a touch probe available, you have to align the
workpiece so that it is fixed with its edges parallel to the machine
axes.