Yaskawa GPD515/G5 - Manual (Page 38)

38 YASKAWA PL.A1000.01 G5 to A1000 - Product Transition Guide
10 Appendix 2 Parameter Cross Reference
10 Appendix 2 Parameter Cross Reference
‹ Parameter Compatibility Table
1.
This document lists the information needed to upgrade from G5 to a new A1000 drive. The A1000 drive must be set for Heavy Duty. First, set A1000
parameter C6-01 to 0.
2.
Check all G5 parameters that have been changed from their default settings by using the Modified Constants Menu.
3.
Set the same control mode used for G5 to A1000.
4. Set parameters as described in this section.
Note: Default Values in the table below are listed for A1000 240 V Class 0.4 kW Drive Using Open Loop Vector Control.
Table 23 Parameter Cross Reference
Parameter Name
G5 A1000 Comments (Gray shading indicates default settings)
No. Default No. Default G5 A1000
Environment Settings
Language Selection for
digital operator display
A1-00 0 A1-00 0
A1-00 A1-00
0: English 0: English
1: Japanese 1: Japanese
2: German 2: German
3: French 3: French
4: Italian 4: Italian
5: Spanish 5: Spanish
6: Portuguese 6: Portuguese
— 7: Chinese
Constant Access Level A1-01 2 A1-01 2
A1-01 A1-01
0: Monitor Custom
0: Operation only
(monitors only)
1: User Selection Parameter 1: User Parameters *
2: QUICK-START (Q)
2: All parameters 3: BASIC (B)
4: ADVANCED (A)
* A2-01 through A2-32 Setting
User setting constant A1-02 2 A1-02 2
A1-02 A1-02
0: V/f 0: V/f Control
1: V/f w/PG Control 1: V/f w/PG Control
2: Open Loop Vector 2: Open Loop Vector
3: Flux Loop Vector 3: Closed Loop Vector
─ 5: Open Loop Vector for PM
─
6: Advanced Open Loop Vector
Control for PM
─
7: Closed Loop Vector Control
for PM
Initialize A1-03 0 A1-03 0
A1-03 A1-03
0: No initialization 0: No initialization
1110: User Setting 1110: User initialize
2220: 2-wire sequence 2220: 2-wire sequence
3330: 3-wire sequence 3330: 3-wire sequence
─ 5550: Reset OPE04
Enter Password A1-04 0 A1-04 0000 ―
Password 2 A1-05 0 A1-05 0000 ―
User setting constant
A2-01 to
A2-32
─
A2-01 to
A2-32
―
If setting A1-01 to 1, refer to the manual and set parameters A2-01
to A2-32.