Yaskawa GPD515/G5 - Manual (Page 52)

10 Appendix 2 Parameter Cross Reference
52 YASKAWA PL.A1000.01 G5 to A1000 - Product Transition Guide
Multi-Function Relay
Output
Multi Function Input
(terminal 25-27)
(terminal M3-M4 for
A1000)
H2-02 1 H2-02 1
12: Timer function output 12: Timer function output
13: Frequency agree 2 13: Frequency agree 2
14: User-Set frequency agree 2 14: User-Set frequency agree 2
15: Frequency detection 3 15: Frequency detection 3
16: Frequency detection 4 16: Frequency detection 4
17: Torque detection 1 (N.C.) 17: Torque detection 1 (N.C.)
18: Torque detection 2 (N.O.) 18: Torque detection 2 (N.O.)
19: Torque detection 2 (N.C.) 19: Torque detection 2 (N.C.)
1A: Reverse run 1A: Reverse run
1B: During baseblock 2 (N.C.) 1B: During baseblock 2 (N.C.)
1C: Motor selection 1C: Motor selection
1D: Regenerating during run 1D: Regeneration during run
1E: Fault restart 1E: Fault restart
1F: Motor overload alarm 1F: Motor overload alarm
20: Drive overheat alarm 20: Drive overheat alarm
─
22: Mechanical weakening
(N.O.)
─ 2F: Maintenance timer
30: During torque limit 30: During torque limit
31: During speed limit 31: During speed limit
Multi-function input
(terminal 26-27)
(terminal M5-M6 for
A1000)
H2-03 2 H2-03 2
─
32: Speed Limit Circuit During
Run
33: Zero servo complete 33: Zero servo complete
37: During run 2 37: During frequency output
─ 38: Drive enabled
─ 39: Kilowatt hour output
─ 3C: Operation mode
─ 3D: Speed Search
─
3E: PID feedback fault (during
loss )
─
3F: PID feedback too high
(fault)
─ 4A: During KEB
─ 4B: During Short Braking
─ 4C: During Fast Stop
─ 4D: oH pre-alarm time limit
─ 4E: During Rr
─ 4F: During Rh
─ 60: Internal Cooling fan fault
─ 61: Pole detection complete
─
90 to 92: DriveWorksEZ,
outputs 1-3
─
100 to 192: Reverse Output of
0-92
Analog Input
Signal level selection
(terminal 13) (terminal
A1 for A1000)
H3-01 0 H3-01 0
In A1000, terminal A1 is multi-functional input terminal.
H3-01 H3-01
0: 0 to +10 V 0: 0 to +10 V (uses lower limit)
1: -10 to 10 V 1: 0 to ±10 V (no lower limit)
Terminal A1 Function
Selection
─ ─ H3-02 0 Parameter H3-02 should be set to 0 in A1000.
Gain (terminal 13)
(terminal A1 for
A1000)
H3-02 100.0 %
H3-03 100.0 % ―
F2-02 100.0 %
Set this parameter when using an analog option card to determine
the bias for the analog reference.
Parameter Name
G5 A1000 Comments (Gray shading indicates default settings)
No. Default No. Default G5 A1000