Yaskawa GPD515/G5 - Manual (Page 60)

10 Appendix 2 Parameter Cross Reference
60 YASKAWA PL.A1000.01 G5 to A1000 - Product Transition Guide
• Analog Input Terminal A1 Function Selection (G5: N/A , A1000: H3-02)
A3 Function Selection (G5: H3-05, A1000: H3-06)
A2 Function Selection (G5: H3-09, A1000: H3-10)
G5: 0 to 1F
A1000: 0 to 31
• Analog Output FM (AM) Monitor Selection (G5, A1000 both use H4-01 (H4-04))
G5: 1 to 38 (enter the last two digits of the monitor to output: U1-□□)
A1000: 000 to 999 (enter the last two digits of the monitor to output: U1-□□)
• Analog Output Terminal FM (AM) Gain (G5, A1000 both use H4-02 (H4-05))
G5: 0.00 to 2.50
A1000: -999.9% to 999.9%
• Analog Output Terminal FM (AM) Bias (G5, A1000 both use H4-03 and H4-06)
G5: -10.0% to +10.0%
A1000: -999.9% to 999.9%
• KEB Deceleration Time (G5, A1000 both use L2-06)
G5: 0.0 to 100.0 s
A1000: 0.00 to 6000.0 s
• Stall Prevention Level during Acceleration(G5, A1000 both use L3-02)
G5: 0 to 200%
A1000: 0 to 150%
• Stall Prevention Level during Run(G5, A1000 both use L3-06)
G5: 30 to 200%
A1000: 30 to 150%
• Drive Mode Display Selection (G5, A1000 both use o1-01)
G5: 4 to 38 (enabled when o1-02 = 4)
A1000: 104 to 4□□, 5□□, 6□□, 8□□ (enabled when o1-02 = 5)
• Monitor Display at Power Up(G5, A1000 both use o1-02)
G5: 1 to 4
A1000: 1 to 5
Table 24 Frequency Reference Setting/Display Units (G5, A1000 both use o1-03)
• Cumulative Operation Time Setting(G5: o2-07, A1000: o4-01)
G5: 0 to 65535H (set in hour units)
A1000: 0 to 9999H (set in 10 hour units)
G5: 0 to 39999 A1000: 0 to 3
0: 0.01 Hz units (default)
1: 0.01 % units
2 to 39: r/min units (set the number of motor poles)
40 to 39999: User-set display (displayed when using the max output frequency) 0 : 0.01 Hz units (default)
1 : 0.01% units
2 : r/min units (calculated by the max output frequency and the no. of motor poles)
3 : User-set units (set using parameters o1-10 and o1-11)