Yaskawa APOGEE FLN P1 - Manual (Page 17)

Connecting Option and Ground Wire
1.
Insert the option (M) into the CN5-A connector (K) located on the drive and fasten it
using one of the included screws (F).
NS MS
K
L
F
M
TX RX
Figure 5 Insert the Option
2.
Connect the ground wire (G) to the ground terminal (H) using one of the remaining
provided screws (F). Connect the other end of the ground wire (G) to the remaining
ground terminal and installation hole on the option (M) using the last remaining
provided screw (F) and tighten both screws to 0.5 ~ 0.6 N m or (4.4 ~ 5.3 in lbs).
5 Installation Procedure
YASKAWA TOEP YAICOM 13 Metasys N2 & Apogee FLN P1 SI-J3 Installation & Technical Manual 17