Yaskawa Varispeed-656 DC5 - Manual (Page 46)

E-36
Setting a User Constant
The group level will be displayed when the DATA/ENTER Key is pressed at the program-
ming mode display.
Use the following procedure to set a constant.
The constant setting (drive mode is changed from Terminal to Operator with programming
mode) has been completed.
Operation Mode
Operation mode is the mode in which the VS-656DC5 can be operated.
Many user constants can't be changed when the VS-656DC5 is operating. Refer to A.1 Mon-
itor Constant List for details.
The following monitor displays are possible in operation mode: The AC power supply fre-
quency, current or voltage, as well as fault information and the fault history.
When running the VS-656DC5 after using Digital Operator, press the MENU Key to enter the
operation mode and then press the DATA/ENTER Key from the operation mode display to bring up the
monitor display. Run commands cannot be received from any other display. (Monitor display in the
operation mode appears when the power is turned ON.)
Step Key
Sequence
Digital Operator Display Remarks
1
2
Press twice.
3
4 Changed to constant reading
(function) level.
5
6
7
8
9 Writes in the new setting.
After a few seconds, the Oper-
ator display is as shown on the
left.
10
EXAMPLE
MENU DC5 ∗ Main Menu ∗
Operation
DC5 ∗ Main Menu ∗
Programming
Group b
Application
Sequence
Function b1
Entry Accepted
Function b1
sequence
Reference Source
Operator
Run Source
Terminals
b1-02 = 1
Terminals
b1-02 = 0
Operator
Run Source
Operator
DATA
ENTER
DATA
ENTER
DATA
ENTER
DATA
ENTER
DATA
ENTER
ESC
IMPORTANT