Yaskawa Varispeed-656 DC5 - Manual (Page 66)

E-56
L5-01 Number of auto restart attempts
[Num of Restarts]
0 0 to 10 − B
L5-02 Auto Restart Operation
Selection
[Restart Sel]
0 0, 1 − B 0: Not output
(Fault contact is not activated.)
1: Output
(Fault contact is activated.)
L8-02 VS-656DC5 Overheat
Pre-alarm Level
[OH Pre-Alarm Lvl]
95 50 to 110 deg − A
L8-03 VS-656DC5 Operation Selection
after Overheat Pre-alarm
[OH Pre-Alarm Sel]
3 1, 3 − A 1: Stops operation.
3: Continues operation.
L8-10 Ground Protection Selection
[Gnd Det Sel]
1 0, 1 − A 0: Ground protection enabled
1: Ground protection disabled
O1-01 Monitor Selection
[User Monitor Sel]
8 4 to 50 Possible B
O1-02 Monitor Selection
after Power Up
[Power-On Monitor]
1 1 to 4 Possible B 1: Output voltage reference
(U1-01)
2: Output voltage feedback
(U1-02)
3: Output current (U1-03)
4: The monitor item set for O1-01
O2-01 LOCAL/REMOTE Key
Enable/Disable
[Local/Remote Key]
1 0, 1 − B 0: Disabled
1: Enabled
O2-02 STOP Key during
Remote Operation
[Oper STOP Key]
0 0, 1 − B 0: Enabled during run command
from the Digital Operator
1: Enabled
O2-04 VS-656DC5 kVA Selection
[Converter Unit Model]
* 00 to FF − B *: Varies depending on VS-
656DC5 capacity.
O2-06 Operation Selection when Digital
Operator is Disconnected
[Oper Detection]
0 0, 1 − A 0: Operation continues even if the
Digital Operator is discon-
nected.
1: VS-656DC5 fault is detected at
Digital Operator disconnection.
O2-07 Cumulative Operation
Time Setting
[Elapsed Time Set]
− 0 to 65535H − A
O2-08 Cumulative Operation Time
Selection
[Elapsed Time Run]
0 0, 1 − A 0: Cumulative time when the VS-
656DC5 is ON.
1: Cumulative VS-656DC5 run
time.
(cont’d)
Constant
No.
Name
[Display]
Initial
Value
Setting
Range
Change
during
Operation
Access
Level
Remarks