TA Triumph-Adler 206ci User Manual
Page 333
10-17
Troubleshooting > Responding to Messages
F
Message
Checkpoints
Corrective Actions
Reference
Page
Failed to send the file
information.
Is the machine and the PC to
which the scanned image is to be
sent connected to the network?
Check the network and SMB settings.
- The network cable is connected.
- The hub is not operating properly.
- The server is not operating properly.
- Host name and IP address
- Port number
Is the account information (user
ID, password) used to access the
shared folder to which the
scanned image is to be sent
incorrect?
Check the following settings of the PC to
which the scanned image is to be sent.
- Host name
- Path
- Login user name
NOTE: If the sender is a domain
user, specify the domain name.
[Login User ID]@[Domain Name]
Example: sa720XXXX@km
- Login password
- Folder share permissions of the
recipient
—
Failed to specify Job
Accounting.*
*
When Auto Error Clear is set to [On], processing resumes automatically after a set amount of time elapses.
—
Failed to specify Job Accounting when
processing the job externally. The job is
canceled. Press [End].
—
Failed to store job retention data.
—
The job is canceled. Press [End].
Insufficient free space in the Job Box.
Try to perform the job again after
printing or deleting data from the Job
Box.
—
Finisher failure.
—
Contact your Service Representative.
Press the System Menu/Counter key,
[Adjustment/Maintenance], [Service
Setting] and then [Reset Disable
Function Mode]. Press [Execute] to
perform Reset Disable Function Mode.
—
Finisher tray is full of paper.
Is the acceptable storage
capacity exceeded for the
document finisher tray?
Remove paper from the document
finisher tray.
—
Fuser unit is not installed.
—
Replace the fuser unit (h-1) to our
specified fuser unit. See the leaflet
supplied with the fuser unit for details.
—