ProSoft Technology PS69-DPS - Manual (Page 10)

Start Here PS69-DPS ♦ CompactLogix or MicroLogix Platform
User Manual Profibus DP Slave Communication Module
Page 10 of 108 ProSoft Technology, Inc.
May 9, 2014
1.1 Software Requirements
Follows are the software requirements for using the PS69-DPS module within a
CompactLogix system. You must have the following software installed on your
computer unless otherwise noted:
CompactLogix System
 RSLogix 5000, V13.00 or higher
MicroLogix 1500 System
 RSLogix 500, V6.30 or higher
1.2 Hardware Requirements
The following minimum hardware is required to use the PS69-DPS PROFIBUS
module.
CompactLogix System
 Personal Computer
 1769: Programmable Controller
 1769: Power Supply
 1769: Right or Left handed Termination End Cap
 Serial Cable for interface to the 1769-Programmable Controller.
MicroLogix 1500 System
 Personal Computer
 1764: MicroLogix 1500 Programmable Controller
 1769: Right handed Termination End Cap
 Serial Cable for interface to the 1764-Programmable Controller.
1.3 Reference Systems
The firmware of the communication module PS69-DPS was developed and
tested with following CompactLogix / MicroLogix Controller types and firmware
revisions.
CompactLogix System
PS69-DPS CompactLogix 1769-L20 CompactLogix 1769-L32E
Firmware V10.2 Firmware V13.18 Firmware V13.28
MicroLogix 1500 System
PS69-DPS MicroLogix 1500 (Processor 1764-LRP/A Rev2.0)
Firmware V10.2 Firmware: OS 1510; Series C ; Revision 9.0