ProSoft Technology MVI46-MBP - Manual (Page 8)

MVI46-MBP ♦ SLC Platform Start Here
Modbus Plus Communication Module
Page 8 of 101 ProSoft Technology, Inc.
February 19, 2008
ƒ CD-ROM drive
ƒ 3.5 inch floppy disk drive
ƒ HyperTerminal or other terminal emulator program capable of file transfers
using Ymodem protocol.
1.2 Package Contents
The following components are included with your MVI46-MBP module, and are
all required for installation and configuration.
Important: Before beginning the installation, please verify that all of the following items are
present.
Qty. Part Name Part Number Part Description
1 MVI46-MBP
Module MVI46-MBP Modbus Plus Communication Module
1 Cable Cable #15, RS232
Null Modem
For RS232 Connection to the CFG Port
1 Cable Cable #14, RJ45 to
DB9 Male Adapter
For DB9 Connection to the CFG Port
1 ProSoft
Solutions
CD Contains sample programs, utilities and
documentation for the MVI46-MBP module.
If any of these components are missing, please contact ProSoft Technology
Support for replacement parts.
1.3 Install the Module in the Rack
If you have not already installed and configured your SLC processor and power
supply, please do so before installing the MVI46-MBP module. Refer to your
Rockwell Automation product documentation for installation instructions.
Warning: You must follow all safety instructions when installing this or any other electronic
devices. Failure to follow safety procedures could result in damage to hardware or data, or even
serious injury or death to personnel. Refer to the documentation for each device you plan to
connect to verify that suitable safety procedures are in place before installing or servicing the
device.
After you have checked the placement of the jumpers, insert MVI46-MBP into the
SLC™ chassis. Use the same technique recommended by Rockwell Automation
to remove and install SLC™ modules.
Warning: This module is not hot-swappable! Always remove power from the rack before
inserting or removing this module, or damage may result to the module, the processor, or other
connected devices.
1 Turn power OFF.