Epson Home Cinema 2350 2800-Lumen Pixel-Shift 4K UHD 3LCD Smart Gaming Projector - Manual (Page 133)

133
Important Safety Instructions
Follow these safety instructions when setting up and using the projector:
• Do not look into the lens when the projector is on. The bright light can damage your eyes. Avoid
standing in front of the projector so you do not block the projected image and the bright light does not
shine into your eyes. Be especially careful if children are around. Do not look into the lens using
optical devices such as loupes or telescopes.
• Do not install or place the projector vertically. Doing so may cause a malfunction.
• When turning on the projector at a distance using the remote control, make sure there is no one
looking into the lens.
• Do not touch the lens with bare hands. You may not be able to project clearly if the surface of the lens
is smeared with fingerprints or oil.
• Do not place the projector on an unstable cart, stand, or table or on a surface that is unable to support
its weight. Otherwise, it could fall or topple causing damage, deformation or an accident and injury.
• Do not operate the projector on its side, or while tilted to one side. Do not tilt the projector more than
10° forward or back.
• Installing the projector on the ceiling or on a wall requires specialist knowledge. If installation work is
not carried out correctly, the projector could fall down. This may result in injury or accidents. Contact
your dealer to carry out the installation work.
• Failure to install the ceiling mount and projector correctly may cause the projector to fall. After
installing the specific Epson mount that supports your projector, make sure you secure the mount to all
of the projector's ceiling mount fixing points. Also, secure the projector and the mounts using wire that
is strong enough to hold their weight.
• When installing the projector in a high position, take measures to prevent it from falling by using wires
to ensure safety in an emergency, such as an earthquake, and to prevent accidents. If the projector is
not installed correctly, the projector could fall. This may result in injury or accidents.
• Do not install in locations where salt damage could occur, or in locations subject to corrosive gas such
as sulphuric gas from hot springs. Otherwise, corrosion could cause the projector to fall. It could also
cause the projector to malfunction.
• When installing or adjusting a ceiling or wall mount, do not use adhesives to prevent the screws from
loosening and do not use oils or lubricants. This may cause the projector case to crack and the
projector to fall from its ceiling mount. This could cause serious injury to anyone under the mount and
could damage the projector.