Epson Home Cinema 2350 2800-Lumen Pixel-Shift 4K UHD 3LCD Smart Gaming Projector - Manual (Page 136)

136
• Do not use sprays containing a flammable gas to remove dirt or dust from parts such as the lens or the
air filter. The inside of the projector can get very hot during use and the gases may ignite, resulting in a
fire. Use a vacuum or hand-operated air blower to remove dirt or dust that has adhered to parts such
as the lens or the air filter.
• Do not use or store the projector or remote control with its batteries in a hot location, such as near a
heater, in direct sunlight, or in a closed vehicle. Thermal deformation or technical malfunction may
occur, which may result in a fire.
• Check the specifications for the power cable. Using an inappropriate power cable could result in fire or
electric shock. The power cable supplied with the projector is intended to comply with power supply
requirements for the country of purchase. If you use the projector in the country where it was
purchased, only use the power cable that came with the projector.
• If you use the projector in a country other than where you purchased it, use the correct power cord for
that country.
• Do not stand on the projector or place heavy objects on it. You may fall over, resulting in injury and
damage to the projector.
• If you are using the projector at altitudes above 4,921 feet (1,500 m), enable the High Altitude Mode
setting in the projector's menu to ensure the projector's internal temperature is regulated properly.
• Do not use the projector outside of the required temperature range below (20 to 80% humidity, no
condensation):
41 to 95 °F (5 to 35 °C) at an altitude of 7500 feet (2286 m) or less, or 41 to 86 °F (5 to 30 °C) at an
altitude of 7500 to 10000 feet (2286 m to 3048 m)
Doing so may cause an unstable display and could lead to projector damage. Do not use or store the
projector where it may be exposed to sudden changes in temperature.
• Do not use or store the projector in places where it might be subjected to high and low extremes of
temperature.
• Do not store the projector outside of the required temperature range of 14 to 140 °F (–10 to 60 °C) or
in direct sunlight for long periods of time. Doing so may cause damage to the case.
• Do not place anything that can become warped or damaged by heat near the exhaust vents. Do not
bring your hands or face close to the vents while projection is in progress. Do not bring your face close
to the projector while it is in use. Hot air from the exhaust vents could cause burns, warping, or other
damage to property.
• Before you move the projector, make sure its power is turned off, the plug is disconnected from the
outlet, and all cables are disconnected. Fire or electric shock may result.
• Never try to remove the lamp immediately after use because it will be extremely hot. Before removing
the lamp, turn off the power and wait at least an hour to allow the lamp to cool completely.