IOGear 2-Port 4K Dual View DisplayPort Matrix KVMP Switch - Manual (Page 4)

4
Safety Instructions
• Read all of these instructions. Save them for future reference.
• This device is for indoor use only.
• Follow all warnings and instructions marked on the device.
• Do not place the device on any unstable surface (cart, stand, table, etc.). If the
device falls, serious damage will result.
• Do not use the device near water.
• Do not place the device near, or over, radiators or heat registers.
• The device cabinet is provided with slots and openings to allow for adequate
ventilation.
To ensure reliable operation, and to protect against overheating, these openings
must never be blocked or covered.
• The device should never be placed on a soft surface (bed, sofa, rug, etc.) as this will
block its ventilation openings. Likewise, the device should not be placed in a built in
enclosure unless adequate ventilation has been provided.
• Never spill liquid of any kind on the device.
• Unplug the device from the wall outlet before cleaning. Do not use liquid or aerosol
cleaners. Use a damp cloth for cleaning.
• The device should be operated from the type of power source indicated on the
marking label. If you are not sure of the type of power available, consult your dealer
or local power company.
• The device is designed for IT power distribution systems with 230V phase-to-phase
voltage.
• To prevent damage to your installation, it is important that all devices are properly
grounded.
• The device is equipped with a 3-wire grounding type plug. This is a safety feature.
If you are unable to insert the plug into the outlet, contact your electrician to replace
your obsolete outlet. Do not attempt to defeat the purpose of the grounding-type
plug. Always follow your local/national wiring codes.
• Do not allow anything to rest on the power cord or cables. Route the power cord and
cables so that they cannot be stepped on or tripped over.
• If an extension cord is used with this device, make sure that the total Ampere ratings
of all products used on this cord does not exceed the extension cord Ampere rating.
Make sure that the total of all products plugged into the wall outlet does not exceed
15 Amperes.
• To help protect your system from sudden, transient increases and decreases in
electrical power, use a surge suppressor, line conditioner, or un-interruptible power
supply (UPS).