vMix Live Production Software Pro - Manual (Page 150)

vMix User Guide
150 / 208
Enable SRT
Check this box to enable the SRT output.
Type
Listener: Listen on the specified Port on all network adapters on the computer for connections. Hostname
is ignored.
Caller: Connect to the specified Hostname and Port.
Rendezvous: Connect to the specified Hostname and Port. The other side must also be set to Rendezvous
with an identical port number specified.
This mode allows connecting through most firewalls automatically.
Latency
Specify the latency of the connection in milliseconds to adapt to network congestion.
The higher this value, the better SRT can handle difficult network conditions.
As a general rule this should be set to at least 4x the ping time destination IP. So 20ms would require a
latency setting of at least 80
This must be set to the same value on both ends.
Passphrase
Specify a password to encrypt the connection. This password must be used by both sides for the
connection to be established.
Stream ID
Optional Stream ID that may be required by your streaming provider to uniquely identify the stream.