Mitsubishi Motors DS5000TK - Manual (Page 159)

USER’S GUIDE
050396 158/173
159
APPLICATION: USING THE DS2251T RTC
(DS1283 EXAMPLE)
The DS2251T or DS2252T use the DS1283 Byte–wide
type real–time clock (RTC). This clock is accessed in a
parallel fashion like a RAM. The user simply writes to the
registers to set the time and control functions. The fol-
lowing program is an example of how to use this clock. It
provides a serial port interface allowing an user to set
and read the time of day. Note that the serial port setup
expects 9600 baud communication and an 11.0592
MHz crystal. If a user’s application uses different val-
ues, this setup must be modified. All of the timekeeping
access is performed in the code under Set Time and Tell
Time. The remainder of this program concerns getting
data in and out of the serial port for display purposes
and has nothing to do with timekeeper access.
; Program DS1283
;
; This program responds to commands received over the serial
; port to set the date and time information in the DS1283
;
; The program first initializes the serial port for communication
; at 9600 baud with eight data bits, no parity, and one stop bit.
;
; After setting the date and time, the program begins execution
; of an infinite loop which sends back the date and time each
; time a character is received.
;
CR EQU 0DH
LF EQU 0AH
;
MCON EQU 0C6H
TA EQU 0C7H
CSEG AT 0
;
MOV TA, #0AAH ; Timed
MOV TA, #55H ; access.
MOV PCON, #0 ; Reset watchdog timer.
ANL MCON, #0FBH ; Turn off PES for memory access.
MOV P2, #0 ; Clear high byte of address.
; for clock access
;
MOV IE, #0
MOV TMOD, #20H ; Initialize the
MOV TH1, #0FAH ; serial port
MOV TL1, #0FAH ; for 9600
ORL PCON, #80H ; baud, with 11.0522 MHz crystal.
MOV SCON, #52H
MOV TCON, #40H
;Messages
MOV DPTR, #TEXT0
LCALL TEXT_OUT
LCALL CHAR_IN
LCALL CHAR_OUT
PUSH ACC
MOV DPTR, #TEXT3
LCALL TEXT_OUT
POP ACC
ANL A, #5FH
CJNE A, #’Y’, TELL_TIME