ICP DAS USA I-7540D User Manual
The i-7540d can-ethernet gateway, User’s manual
Advertising
Table of contents
Document Outline
- 1. Introduction
- 1.1 Features
- 1.2 Specifications
- 1.3 VxComm Technology
- 2. Hardware
- 3. Software Utilities
- 3.1 i-7540D Utility
- 3.1.1 Install & uninstall the i-7540D Utility
- 3.1.2 How to configure the module parameters
- 3.1.3 How to set the Bus Timing Registers
- 3.1.4 How to set the Acceptance Code and Mask
- 3.1.5 Enable Error Response
- 3.1.6 Enable Time-stamp Response
- 3.1.7 How to change web ID/PASSWORD configuration
- 3.1.8 How to test the module transmission performance
- 3.1.9 How to use CAN Bus Pair Connection
- 3.2 MiniOS7 Utility
- 3.3 VxComm Utility
- 3.1 i-7540D Utility
- 4. Support Command List
- 4.1 tIIILDD…<CR>
- 4.2 TIIIL<CR>
- 4.3 eIIIIIIIILDD…<CR>
- 4.4 EIIIIIIIIL<CR>
- 4.5 99S
- 4.6 99C
- 4.7 99RA
- 4.8 99#P01
- 4.9 99#P02
- 4.10 99#P1
- 4.11 99#P1B
- 4.12 99$P0105BBDSP
- 4.13 99$P0205BBDSP
- 4.14 99$P114PBCC…MM…ET
- 4.15 99$P1B04TTRR
- 4.16 99#PWID
- 4.17 99#PWPW
- 4.18 99$PWIDLLxxxxx…
- 4.19 99$PWPWLLxxxxx…
- 4.20 99#PPC
- 4.21 99#PPIP
- 4.22 99$PPCLLABC
- 4.23 99$PPIPxxx…
- 4.24 General Error codes for commands from port 10003
- 5. VxComm Applications
- 6. Application with PISO-CAN 200/400 T
- 7. Diagnostics and Troubleshooting