Interphase Tech RAS Communications Controller 5536 - Manual (Page 110)

Setting Up or Removing Channels as RAS Ports
90 Interphase Corporation
Setting Up or Removing Channels as RAS
Ports
If you need to add ISDN or digital modem channels as RAS-
capable devices after software installation, use the Remote
Access Setup dialog box and the Add RAS Device dialog box
to set up the channels as RAS ports. You can also use the
Remote Access Setup dialog box to remove channels from the
RAS device list so that the channels are no longer designated
as RAS devices.
Setting Up RAS Port Designations
To set up ISDN or digital modem channels as RAS ports, do
the following:
1. Validate the RAS support properties for the appropriate
driver type, as follows:
a. From the Start menu, select Settings, and then
Control Panel. Then double-click the Network
icon, and select the Adapters tab.
b. Select Interphase 553x ISDN RAS Support to set
up ISDN RAS ports, or select Interphase 5536
Digital Modem RAS support to set up digital
modem RAS ports.
c. Click the Properties button.
d. When the RAS Support General dialog box appears,
click OK to confirm the general RAS support
properties for the RAS ports being added.
2. When the Network Adapters dialog box reappears,
select the Services tab to display the Services dialog
box.