Interphase Tech RAS Communications Controller 5536 - Manual (Page 135)

Chapter 7: Managing Serial Driver COM Ports
5536 PRI RAS Communications Controller Users Guide 115
4. Click OK to confirm the parameters. (The parameters
are generally correct.)
The HyperTerminal window reappears, with the cursor
in the active mode.
5. Type at (lower or upper case) and press Enter.
OK appears below the command. The status bar at the bottom
of the window indicates that you are connected, and displays
the duration of the connection, as shown in the following
illustration:
Figure 7-3. Correct Connection Status on HyperTerminal
If the window remains blank, or no connection is indicated in
the status bar, you might be using a COM port that is not
assigned to a digital modem. Verify that you have selected a
COM port connected to a digital modem.
Check your Windows NT documentation for assistance.