Interphase Tech RAS Communications Controller 5536 - Manual (Page 76)

Setting Up Channels as RAS Ports
56 Interphase Corporation
4. Select a port usage option, and click OK.
The Remote Access Setup dialog box reappears.
5. To quickly add and configure remaining channels as
RAS ports with the same properties as a configured
port, do the following:
a. Select the port whose properties you want to copy,
and click the Clone button.
The next available channel is added to the port list.
The port usage properties are copied from the
selected port.
b. Click the Clone button repeatedly until you have
configured all the RAS ports you need. (Or until you
receive the message There are no more ports of the
specified type to clone.)
Or to configure the channels’ port usage properties one-
by-one, click Add to display the Add RAS Device
dialog box. Then repeat Steps
2 through 4 .
6. Do the following to select the network protocols to be
bound to the board:
a. On the Remote Access Setup dialog box, click
Network to display the Network Configuration
dialog box: