Interphase Tech RAS Communications Controller 5536 - Manual (Page 126)

Setting Up Call Properties
106 Interphase Corporation
You can select multiple ports of the same type in the tree view
(that is, multiple ISDN or COM ports) and configure them
together.
The way incoming calls are routed depends on the Channel
type values selected and the Local subscriber numbers entered.
Local
Subscriber
Number Enter the local subscriber number(s) for a port to route an
incoming call to that port when several ports are able to
accept the call. The local subscriber number(s) must match
the subscription number(s) your local Telco has assigned to
your line.
This field is available only at the port level. If multiple types
of ports accept the same channel type, it is required for each
affected port. Otherwise, it is optional. Ports of the same
type, such as COM ports, can use the same local subscriber
number(s).
NOTE: On a single-PRI port card, this field is available for
the ISDN RAS port only if the ISDN physical line supports
Multiple Subscriber Numbers (MSN).
Modem
Initialization
Strings
(Hayes
Commands) Use the Modem Initialization Strings field to enter
initialization strings for incoming and outgoing calls, if
needed.
This field is available only for the DM RAS modem port and
for DM serial driver COM ports. It is optional.
Field Description