Interphase Tech RAS Communications Controller 5536 - Manual (Page 95)

Chapter 5: Setting Up WAN Firmware and Hardware
5536 PRI RAS Communications Controller Users Guide 75
Use the following buttons to set up firmware information:
N
OTES
The Properties button in the Firmware section is disabled
because this product has no configurable layers.
If you load firmware, save changes and restart the system
as described in
Saving WAN Setup Properties on page 87 .
Click... To do this...
Load Download the current firmware to the selected card.
CAUTION: This option disconnects all current RAS-
connected users and disables the RAS Server. After a
firmware download, the RAS Server must be re-enabled
by being stopped and restarted, as follows:
1. From the Start menu, select Settings, and then Control
Panel. Then double-click the Services icon to display the
Services dialog box.
2. Select Remote Access Server from the list of services,
and click Stop.
3. When a message informs you that the RAS Port Manager
will also be stopped, click OK.
A message informs you that RAS is being stopped.
4. To restart the RAS Server, select Remote Access Server
and click Start.
5. Select Virtual Motion RAS Port Manager and click
Start.
New Set alternate firmware as the current firmware.