Interphase Tech RAS Communications Controller 5536 - Manual (Page 114)

Setting Up or Removing Channels as RAS Ports
94 Interphase Corporation
Removing RAS Port Designations
If you need to remove a channel from the RAS device list, do
the following:
1. Access the Remote Access Setup dialog box, as
described in Steps 1 through 3 of Setting Up RAS Port
Designations on page 90 .
2. Select the channel in the list on the Remote Access
Setup dialog box, and click Remove.
3. When you have finished removing RAS ports, on the
Remote Access Setup dialog box, click Continue.
The Network Services dialog box appears.
4. To make the settings take effect, click Close.
A message informs you that you must shut down and
restart your computer before the settings take effect.
5. Continue as follows:
– If the system is a basic Windows NT system, without
the Windows NT Service Pack installed, click Yes to
restart the computer.
– If the Windows NT Service Pack is installed, click
No. Then reinstall the Service Pack. (Service Pack 3
or higher is recommended.) Restart the system when
prompted after you complete the Service Pack
installation.