Interphase Tech RAS Communications Controller 5536 - Manual (Page 121)

Chapter 6: Setting Up Calls
5536 PRI RAS Communications Controller Users Guide 101
Moving an Incoming Call Number Up or Down
To rearrange incoming call numbers in the Filtering list, select
the number you want to move, and click the Up or Down
button.
Removing an Incoming Call Number
To remove an incoming call number from the Filtering list,
select the number you want to remove, and click Remove.
(You can remove only one number at a time.)
Activating Incoming Filter Settings
After changing ISDN RAS Incoming Filter settings, to activate
new settings, restart your computer. (If the Microsoft Windows
NT Service Pack is installed, reinstall the Service Pack before
restarting the system. Then restart the system when prompted
at the end of the Service Pack installation.)
Setting Up Call Properties
The Call Setup dialog box enables you to set up properties for
filtering and routing calls. You can route calls for ISDN or
digital modem ports toward RAS, or for Serial COM ports
toward legacy applications.
• From the RAS Support Incoming Filter dialog box,
click the Call Setup button. (For information about the
Incoming Filter dialog box, see
Setting Up RAS Support
Properties on page 95 .)
• From the Cards section of the WAN Adapters Setup
dialog box, select the card for which you want to set up
call properties. Then right-click and select Call Setup
from the shortcut menu.