Interphase Tech RAS Communications Controller 5536 - Manual (Page 117)

Chapter 6: Setting Up Calls
5536 PRI RAS Communications Controller Users Guide 97
4. View or configure general ISDN or Digital Modem
RAS support parameters, as described in the following
table:
5. After changing RAS support settings, click OK.
Use this
Parameter..
To do the following...
Adapter Identify the status and network name of the 5536 driver.
The LED represents the driver status. Green means that the
driver is running, and gray means that it is not running.
The numeric suffix in the name is the logical network
adapter number assigned by Windows NT.
Idle Timeout Specify how many seconds of inactivity to allow before the
Idle timer ends the connection. The Idle timer is an inactivity
timer used to disconnect an ISDN connection when no data
traffic is exchanged.
This timer setting applies to all of the board’s ISDN B
channels.
To disable the Idle Timeout, enter
0
.
WAN
Adapter View the adapter name assigned by the system.
SecurID
support Specify whether incoming calls must supply additional
security information before connecting to the RAS Server.
Security information is included in the PPP authentication
frames received at the beginning of the connection. It is
extracted from the PPP frames and submitted to the
ACE/Server through the SecurID driver and service, and the
local ACE/Agent.
This option is available only if an ACE/Agent is locally
installed (check the presence of the aceclnt.dll file).
Separator
character Specify the character used to separate and distinguish the
SecurID information inside the user identity. The default
value is @.