Seiko Group TM-L60 - Manual (Page 22)

Chapter 5 Cautions while Using
the Printer
5-1 Panel Switches and Commands
n Switches
(1) Power switch
[Function] Turns the power supply on/off.
[Note]
l
The RAM is initialized after turning off the circuit power supply.
l
Do not touch the power supply switch during printing.
l
When label paper is used, the printer automatically sets the la-
bel at the starting position for printing just after turning the power
switch on. When label paper is selected, the printer automati-
cally detects label paper position and performs paper feeding.
(Paper feed amount varies by the type of label paper.)
(2) Paper-feed switch
[Function] If this switch is pressed, paper is fed one line based on the cur-
rently specified line spacing. If this switch is held for 200 ms or
more, paper is fed as long as the switch is pressed, and stops
when the switch is released. If line spacing is set to 0, paper is
fed while the switch is pressed.
l
The defined macro is executed when the switch is pressed in
the macro executing command standby state.
l
Paper is fed by operating this switch, except during printing, in
an error state, and in the macro executing command standby
state.
[Note]
l
When label is selected, paper feeding is performed in label units
regardless of the predetermined paper feed amount.
l
Paper feeding is performed at the paper near-end state.
l
Pressing the PAPER FEED button recovers from waiting state
of label ejection command (GS FF) execution or from self-test
printing standby state.
l
Paper is not be fed when the printer cover is open.
l
The paper-feed switch can be enabled or disabled with ESC c5
command. When this switch is disabled, you cannot feed paper
with the switch.
16