Seiko Group TM-L60 - Manual (Page 31)

Chapter 6 Software Control
6-1 Printer Control
n Controlling the printer with commands
The printer is controlled by “commands” that can change the size of the charac-
ters, and perform other functions.
See the character code table.
There are two types of commands.
One-byte commands
l
HT Horizontal tab
l
LF Print and line feed
Several-byte commands
l
ESC SP Set character right-side spacing
l
ESC 3 n Set line spacing using minimum units
n How to use this table.
Horizontal by vertical hex
ie. 4A = J
< >H denotes hexadecimal
< > denotes decimal numbers
(Refer to APPENDIX D Character Code Tables)
Hexadecimal
Binary
I I
Hexadecimal Binary Decimal numbers
25