Seiko Group TM-L60 - Manual (Page 47)

[Notes]
l
The transmitted status is only one byte and the data is as shown
in the following table.
l
If nothing is connected with Drawer kick-out connector, bit 0 of n
is always “1".
l
When DTR/DSR control is selected, one byte is transmitted af-
ter confirming that the host computer is ready to receive data
(DSR is SPACE).
l
When XON/XOFF control is selected, one byte is transmitted
without checking the DSR signal.
l
When DTR/DSR control is selected, if the host computer is not
ready to receive data (DSR is MARK), the printer waits until it
becomes ready.
V a l u e
B i t Function 0 1
0 Pin 3 level "LOW" "HIGH"
1 Undefined
2 Undefined
3 Undefined
4 Unused Fixed to 0
5 Undefined
6 Undefined
7 Undefined
ESC v
[Name] Transmit printer status
[Format] <1B>H<76>H
[Description] The current printer status is transmitted to the host computer.
[Notes]
l
The transmitted status is only one byte and the data is as shown
in the following table.
l
When DTR/DSR control is selected, one byte is transmitted af-
ter confirming that the host computer is ready to receive data
(DSR is SPACE).
l
When XON/XOFF control is selected, one byte is transmitted
without checking the DSR signal.
l
When DTR/DSR control is selected, if the host computer is not
ready to receive data (DSR is MARK), the printer waits until it
becomes ready.
41