Seiko Group TM-L60 - Manual (Page 57)

[Notes]
l
The syntax to be used when setting data in the print buffer
should be based upon GS CO.
l
For count mode, see GS Cl or GS C;.
With counting up
l
If the counter value set by this command goes out of the counter
operation range set by GS Cl or GS C;, it will be forced to
convert to the minimum by GS c.
With counting down
l
If the counter value set by this command goes out of the counter
operation range set by GS C1 or GS C;, it will be forced to
convert to the maximum by GS c.
GS f n
[Name] Select font for HRI characters.
[Format] <1D>H<66>H<n>
[Range] n = 0, 1
[Description] Selects a font for the HRI characters used when printing a bar
code.
l
n selects the font from the following table.
n F o n t
0 Font A
1 F o n t B
l
HRI means Human Readable Interpretation.
[Notes]
l
HRI characters are printed at the position specified by GS H.
[Default] n = 0
[Reference] GSH
GS h n
[Name] Select height of bar code
[Format] <1D>H<68>H<n>
[Range] 1
≤ n ≤
255
[Description] Selects the height of the bar code.
l
n specifies the number of dots in the vertical direction.
[Default] n= 162
51