Evaluation workflow, Syngo osteo ct evaluation workflow – Siemens syngo CT 2005C User Manual
Page 282
Advertising
282
syngo Osteo CT
Evaluation Workflow
After loading the images into the syngo Osteo CT appli-
cation, press “Start Evaluation“.
Check the correct positioning of the ROIs in the Calibra-
tion phantom. You can change the position by moving
the two circles.
Correcting contour lines
You can perform correction of the contours by moving
the base points. The following order is recommended:
Water
equivalent
Bone
equivalent
C2-025.630.01.01.02_APPLICATIONGUIDE_SPIRIT.book Page 282 Friday, April 8, 2005 9:55 AM
Advertising