Siemens EMOTION 16-Jun - Manual (Page 108)

108
Workflow Information
Scan
Select single scan protocol or all scan protocols you
want to modify in this subsection. Additionally you can
select the scan mode entries:
– Sequence
– Spiral
– Multiscan
– CAREVision
The displayed parameters depend on the selection you
have made.
• If no special scan mode is selected, the so called
mixed mode is active. The mixed mode means the
user can choose scan ranges from different
modes(Spiral, Sequence, Multiscan, or CAREVi-
sion modes). If the control in one mode is not appli-
cable, the control in mixed mode is not shown in
<Parameters Area>.
A checkbox <Including topogram> is shown below
the parameter grid. When the checkbox is selected, an
information line is added to the parameter grid. The
line is placed immediately before the ranges belonging
to the topogram, you might have to scroll to the right
side of the line to get the information visible.