Troubleshooting & repair, Stator/rotor removal and replacement (continued) – Lincoln Electric COMMANDER SVM153-A User Manual
Page 131
TROUBLESHOOTING & REPAIR
F-78
F-78
COMMANDER 500
CENTER PANEL
LIFT FRAME
WELDMENT
BASE
FUEL TANK
SUPPORTS
FAN BAFFLE
FIGURE F.38 – LIFT FRAME AND ASSOCIATED COMPONENT REMOVAL
STATOR/ROTOR REMOVAL AND REPLACEMENT (CONTINUED)
In steps 20 – 24, the lift frame weldment, fuel
tank supports, and fan baffle are removed as a
unit. See Figure F.38.
20. Using the 3/8" wrench, remove the two
bolts (at top) that hold the center panel to
the lift frame weldment.
21. Using the 1/2" wrench, remove the two
bolts (at bottom) that hold the center panel
to the lift frame weldment.
22. With the 3/8" wrench, remove the nuts, lock
washers, and flat washers from the two
studs that hold the fan baffle to the
machine base.
23. Using the 3/4" wrench, remove the four
bolts, lock washers, and nuts from the bot-
tom of the lift frame weldment.
24. Carefully remove the lift frame weldment,
fuel tank supports, and attached fan baffle.
You will need to lift the fan baffle off the two
studs on the machine base, then cock it
slightly to remove it.