Lincoln Electric COMMANDER SVM153-A - Manual (Page 88)

TROUBLESHOOTING & REPAIR
F-35 F-35
COMMANDER 500 Retur
n to Section TOC
Retur
n to Section TOC
Retur
n to Section TOC
Retur
n to Section TOC
Retur
n to Master TOC
Retur
n to Master TOC
Retur
n to Master TOC
Retur
n to Master TOC
FRONT
CONTROL
PANEL
SCREWS
SCREW
FIGURE F.13 – FRONT CONTROL PANEL REMOVAL
STATOR VOLTAGE TEST (CONTINUED)
TEST PROCEDURE
1. Turn the engine off.
2. Using the 3/8" wrench, remove the four
screws holding the front control panel to the
case top and sides. See Figure F.13.
(There are two screws on the top and one
screw on each side.)
3. Carefully lower the front control panel.
4. Using the 3/8" wrench, remove the front left
and right side panels.
5. Using the 3/4" wrench, remove the internal
leads from the output terminals. Insulate the
leads.