Troubleshooting & repair – Lincoln Electric PRECISION TIG 275 SVM162-B User Manual
Page 100
F-54
F-54
PRECISION TIG 275
TROUBLESHOOTING & REPAIR
SCR BRIDGE ASSEMBLY REMOVAL AND REPLACEMENT (continued)
REMOVAL PROCEDURE
1. Remove input power to the TIG 275
machine.
2. Using the 3/8” nut driver, remove the case
sides and top.
3. Label and cut leads G1 and G2.
See
4. Label and cut leads G3 and G4. S
ee
5. Remove the 1/2 “ nut securing leads B and
6. Using a 7/16” nut driver, disconnect Pos.
lead and lead 218.
7. Using a 1/2” nut driver, disconnect Pos.
lead and lead 218.
8. Using a 1/2” nut driver, remove lead 216
and aluminum lead X1 connecting to the
main transformer.
. Note
washer placement upon removal.
9. Using a 1/2” nut driver, disconnect lead
220A and shunt from the output bridge.
See
10. Using a 3/8” nut driver, remove the four
SCR bridge mounting bolts. Note insulator
washer placement upon removal.
REPLACEMENT PROCEDURE
1. Replace the SCR bridge.
2. Replace the four SCR bridge mounting
bolts previously removed.
Note: Be sure to replace insulating wash-
ers in their proper positions.
3. Reconnect lead 218 and Pos. lead previ-
ously removed.
4. Replace the shunt and lead 220A previous-
ly removed.
5. Replace the 1/2” bolt securing lead 216 and
the aluminum lead X1 originating from the
main transformer.
6. Reconnect the negative lead to the free
wheeling diode.
7. Replace the 1/2” bolt securing leads B and
217 previously removed.
8. Reconnect leads G1, G2, G3, and G4.
Splice, solder and insulate as necessary.
9. Replace case sides and top.