Scr operation, Theory of operation – Lincoln Electric PRECISION TIG 275 SVM162-B User Manual

Page 45

Advertising
background image

E-7

E-7

PRECISION TIG 275

Return

to

Section

TOC

Return

to

Section

TOC

Return

to

Section

TOC

Return

to

Section

TOC

Return

to

Master

TOC

Return

to

Master

TOC

Return

to

Master

TOC

Return

to

Master

TOC

SCR OPERATION

A silicon controlled rectifier (SCR) is a three-terminal

device used to control rather large currents to a load.

An SCR acts very much like a switch. When a gate sig-

nal is applied to the SCR, it is turned ON and there is

current flow from anode to cathode. In the ON state

the SCR acts like a closed switch. When the SCR is

turned OFF there is no current flow from anode to cath-

ode. Thus, the device acts like an open switch. As the

name suggests, the SCR is a rectifier, so it passes cur-

rent only during positive half cycles of the AC supply.

The positive half cycle is the portion of the sine wave in

which the anode of the SCR is more positive than the

cathode.

When an AC supply voltage is applied to the SCR, the

device spends a certain portion of the AC cycle time in

the ON state and the remainder of the time in the OFF

state. The amount of time spent in the ON state is con-

trolled by the gate.

An SCR is fired by a short burst of current into the gate.

This gate pulse must be more positive than the cath-

ode voltage. Since there is a standard PN junction

between gate and cathode, the voltage between these

terminals must be slightly greater than 0.6V. Once the

SCR has fired, it is not necessary to continue the flow

of gate current. As long as current continues to flow

from anode to cathode, the SCR will remain on. When

the anode to cathode current drops below a minimum

value, called holding current, the SCR will shut off.

This normally occurs as the AC supply voltage passes

through zero into the negative portion of the sine wave.

If the SCR is turned on early in the positive half cycle

the conduction time is longer, resulting in greater SCR

output. If the gate firing occurs later in the cycle the

conduction time is less, resulting in lower SCR output.

THEORY OF OPERATION

FIGURE E.9 – SCR OPERATION

NOTE: AS THE GATE
PULSE IS APPLIED
LATER IN THE CYCLE
THE SCR OUTPUT
IS DECREASED.

ANODE

CATHODE

GATE

GATE

OUTPUT

INPUT

Advertising