Troubleshooting & repair, Warning – Lincoln Electric PRECISION TIG 275 SVM162-B User Manual
Page 49
ELECTRIC SHOCK can kill.
*Have an electrician install and service
this equipment. Turn the machine
OFF before working on equipment.
Do not touch electrically hot parts.
Sometimes machine failures appear to be due to PC
Board failures. These problems can sometimes be
traced to poor electrical connections. To avoid prob-
lems when troubleshooting and replacing PC Boards,
please use the following procedure:
1. Determine to the best of your technical ability that
the PC Board is the most likely component causing
the failure symptom.
2. Check for loose connections at the PC Board to
assure that the PC Board is properly connected.
3. If the problem persists, replace the suspect PC
Board using standard practices to avoid static elec-
trical damage and electrical shock. Read the warn-
ing inside the static resistant bag and perform the
following procedures:
PC Board can be damaged by
static electricity.
• Remove your bodyʼs static charge
before opening the static-shielding
bag. Wear an anti-static wrist
strap. For safety, use a 1 Meg ohm
resistive cord con nected to a
grounded part of the equipment
frame.
• If you donʼt have a wrist strap,
touch an unpainted, grounded,
part of the equipment frame. Keep
touching the frame to prevent stat-
ic build-up. Be sure not to touch
any electrically live parts at the
same time.
• Tools which come in contact with the PC Board must
be either conductive, anti-static or static-disipative.
• Remove the PC Board from the static-shielding bag
and place it directly into the equipment. Donʼt set the
PC Board on or near paper, plastic or cloth which
could have a static charge. If the PC Board canʼt be
installed immediately, put it back in the static-shielding
bag.
• If the PC Board uses protective shorting jumpers,
donʼt remove them until installation is complete.
• If you return a PC Board to The Lincoln Electric
Company for credit, it must be in the static-shielding
bag. This will prevent further damage and allow prop-
er failure analysis.
4. Test the machine to determine if the failure symp-
tom has been corrected by the replacement PC
Board.
.......................................................................................
N
NO
OT
TE
E::
It is desirable to have a spare (known good) PC
Board available for PC Board troubleshooting.
N
NO
OT
TE
E::
Allow the machine to heat up so that all electri-
cal components can reach their operating tem-
perature.
5. Remove the replacement PC Board and substitute
it with the original PC Board to recreate the original
problem.
a. If the original problem does not reappear
by substituting the original board, then the
PC Board was not the problem. Continue
to look for bad connections in the control
wiring harness, junction blocks, and termi-
nal strips.
b. If the original problem is recreated by the
substitution of the original board, then the
PC Board was the problem. Reinstall the
replacement PC Board and test the
machine.
6. Always indicate that this procedure was followed
when warranty reports are to be submitted.
N
NO
OT
TE
E:
Following this procedure and writing on the
warranty
report,
“INSTALLED
AND
SWITCHED PC BOARDS TO VERIFY PROB-
LEM,” will help avoid denial of legitimate PC
Board warranty claims.
F-3
F-3
PRECISION TIG 275
TROUBLESHOOTING & REPAIR
PC BOARD TROUBLESHOOTING PROCEDURES
ATTENTION
Static-Sensitive
Devices
Handle only at
Static-Safe
Workstations
WARNING