Lexicon RV-8 - Manual (Page 136)

Audio Controls Lexicon
4-4
AUDIO CONTROLS (continued)
TILT EQ –3.0dB to +3.0dB
Controls the amount of tilt equalization applied to the Main Zone
audio output connectors labeled Front L/R, Center and Sub. This
parameter setting affects the entire frequency spectrum with a
hinge point at 1kHz. As the setting increases, frequencies higher
than 1kHz are boosted while frequencies lower than 1kHz are
simultaneously cut. As the setting decreases, frequencies higher
than 1kHz are cut while frequencies lower than 1kHz are
simultaneously boosted. The TILT EQ Parameter Settings graph on
the next page indicates the frequency response of all TILT EQ
parameter settings.
LOUDNESS ON, OFF
Controls the amount of low-frequency boost that is automatically
applied to the Main Zone audio output connectors labeled Front L/R,
Center and Sub. When ON is selected, loudness compensation is
automatically applied, based on volume level. As volume level
increases, the amount of boost automatically decreases. The loudness
contour is optimized for input sources calibrated to THX reference
levels. When OFF is selected, no loudness compensation is applied.
The LOUDNESS Parameter Settings graph on the next page
indicates the frequency response that is automatically applied when
the LOUDNESS parameter is set to ON and Main Zone volume level
is adjusted.
AUDIO CONTROLS
BASS
TREBLE
TILT EQ
LOUDNESS
BALANCE
FADER
ZONE2 BALANCE
MAIN MENU
MODE ADJUST
AUDIO CONTROLS
TUNER PRESETS
AUDIO CONTROLS
BASS
TREBLE
TILT EQ
LOUDNESS
BALANCE
FADER
ZONE2 BALANCE
MAIN MENU
MODE ADJUST
AUDIO CONTROLS
TUNER PRESETS
ON
OFF
-3.0 to +3.0dB
SETUP
ZONE3 BALANCE ZONE3 BALANCE
SETUP
AUDIO CONTROLS TILT EQ AUDIO CONTROLS LOUDNESS