Lexicon RV-8 - Manual (Page 198)

Appendix A Lexicon
A-2
SPECIFICATIONS
Audio Input & Output Connectors
Analog Audio Inputs Eight stereo (RCA) or five stereo and one 5.1-channel or 2
stereo and two 5.1-channel connectors
Digital Audio Inputs • Four S/PDIF coaxial (RCA) and four S/PDIF optical
connectors
• Coaxial and optical input connectors conform to IEC-
958, S/PDIF standards
• Accepts 44.1, 48, 88.2 and 96kHz sample rates
• Accepts 16-24-bit PCM audio, Dolby Digital, DTS, DTS-
ES discrete and DTS-96K data formats
Main Zone Audio
Outputs Eight unbalanced (RCA) connectors for Front L/R, Center,
Sub, Side L/R and Rear L/R
Zone 2 Audio Outputs • One unbalanced (RCA, variable output level) stereo con-
nector
• One unbalanced (RCA, fixed output level) stereo connector
• One S/PDIF coaxial (RCA) connector and one optical con-
nector
Zone 3 Audio Outputs One stereo (RCA, variable output level) connector
Headphone One stereo (1/4-inch phone) connector
Amplifier Seven channels, two channels can be assigned to Zone 2 or
Zone 3
Main Zone Audio Performance
A/D Conversion 24-Bit, 96kHz, dual-bit ΔΣ architecture
D/A Conversion 24-Bit, 44.1 to 192kHz, multibit ΔΣ architecture
*Frequency Response 20Hz to 20kHz, +0.1dB/–0.1dB, –0.25dB at 40kHz,
–0.5dB at 40kHz, reference 1kHz
*THD + Noise Below 0.02%, 20Hz to 20kHz, 140W Rms all channels driven
*Dynamic Range • 105dB minimum, 22kHz bandwidth, “A” weighted
• 102dB minimum, 22kHz bandwidth, unweighted
*Signal-to-Noise Ratio • 105dB minimum, 22kHz bandwidth, “A” weighted
• 102dB minimum, 22kHz bandwidth, unweighted
Input Sensitivity 200mV Rms (2V Rms for maximum output level) at 0dB
input gain
Input Impedance 100kΩ in parallel with 150pF
Preamp Output Level • 150mV Rms typical, 6V Rms maximum (RCA connectors)
• Maximum value with full-scale input signal and volume
at +12dB
Preamp Output
Impedance 500
Ω
in parallel with 150pF (RCA connectors)
Zone 2 and Zone 3 Audio Performance
A/D Conversion 24-Bit, 44.1 to 96kHz, multibit ΔΣ architecture (Zone 2 only)
D/A Conversion 24-Bit, 44.1 to 192kHz, multibit ΔΣ architecture
Frequency Response 10Hz to 20kHz, +0.1dB/–0.25dB, –0.75dB at 40kHz,
reference 1kHz
THD + Noise Below 0.005% at 1kHz, (1V Rms output level)
Dynamic Range 101dB minimum, 22kHz bandwidth
Signal-to-Noise Ratio 101dB minimum, 22kHz bandwidth
Input Sensitivity 200mV Rms (4V Rms for maximum output level)
Input Impedance 100kΩ in parallel with 150pF
Preamp Output Level • 200mV Rms typical, 4V Rms maximum
• Maximum value with full-scale input signal and volume
at 0dB
Preamp Output
Impedance 300
Ω
in parallel with 150pF
Video Input & Output Connectors
Video Inputs Five composite (RCA), five S-Video and three component
video (RCA)
Video Outputs Two composite (RCA, one monitor and one Zone 2), two
S-Video (one monitor and one Zone 2) and one component
(RCA)
Main Zone Audio Performance