Lexicon RV-8 - Manual (Page 228)

Appendix C Lexicon
C-10
PROGRAMMING MACRO BUTTONS
A “macro” is a series of commands that can be sent with the push of a
single button. There are two types of macro functions that can be
programmed: functions involving the M1, M2 and M3 buttons;or
functions involving the POWER and SYSTEM OFF buttons. Each of
these buttons is designed to send up to 20 commands. The 10 device
buttons can also send a macro of up to 20 commands when the device
button is pressed for more than one second while on the HOME page
of the remote control.
Note:
If the POWER or SYSTEM OFF buttons are programmed with a macro, they
will no longer function as ON and OFF buttons for components. To restore
their original on and off function, erase any macros programmed onto them.
PROGRAMMING MACRO FUNCTIONS TO M1, M2, M3,
POWER AND SYSTEM OFF BUTTONS
To program macro functions to the M1, M2, M3, Power, System
Off buttons:
1. Go to the SETUP mode by pressing the HOME and ENT button
simultaneously for three seconds.
2. Press the MACRO button next to the LCD screen.
3. Press the macro button (M1, M2, M3, Power or System Off)
being programmed.
4. Press the functional buttons you wish to store in the device
macro button you selected, in the order you want them
stored. Up to 20 commands can be stored.
5. Be sure to end a macro on the Device page that you would like it
to remain on when the macro is sent in normal use.
6. Store the commands programmed into the macro button by
pressing the CH UP button.
7. Repeat from step 3 until you have programmed all of the Macros
that you require.
8. When programming is complete, press the HOME button. Exit
from the SETUP mode by pressing the HOME button once again.
Note:
Do not press the HOME button at the beginning of a macro, or it will not
work. The HOME button can be used at any other step in a macro. The M1,
M2, M3, POWER and SYSTEM OFF macros are system-wide, which means
they will function the same no matter what device is being used when they
are programmed.
PROGRAMMING MACRO FUNCTIONS TO THE TEN
DEVICE BUTTONS
To program Macro function to the 10 device buttons:
1. Go to the SETUP mode by pressing the HOME and ENTER buttons
simultaneously for three seconds.
2. Press the MACRO button next to the LCD screen.
3. Important: Press the PAGE button.
4. Press one of the 10 device buttons.
5. Press the functional buttons you wish to store in the device macro
button you selected in the order you want them stored. Up to 20
commands can be stored.
Note:
Do not press the HOME button at the beginning of a macro, or it will
not work. The HOME button can be used at any other step in a macro.
6. Be sure to end your macro on the Device page that you would like
to remain on when the macro is sent in normal use.